ZINGA VARIOUS APPLICATION METHODS

ZINGA can be applied using a normal paintbrush (natural hairs) or a short-fibre roller for smaller applications or to perform a stripe-coat.

In order to fill the profile of the substrate better, it is advised to dilute ZINGA 3-5% (mass on mass – see below dilution table).

This will give a smoother finish.

It is always recommended to treat corners, sharp edges, bolts and nuts with a stripe coat (by brush) before applying a uniform coat by spray.

For more technical data, see ZINGA Technical Data Sheet.

application 2
vam 1

ZINGA APPLICATION BY CONVENTIONAL SPRAY

ZINGA can be applied using a conventional spray gun. In order to ensure good circulation of the ZINGA, it should be diluted 10 to 20% (mass on mass – see below dilution table) depending on pressure at the nozzle and nozzle opening.

More dilution for the same nozzle will give a smoother surface finish (less porous).

For more technical data, see ZINGA Technical Data Sheet.

vam 2

ZINGA APPLICATION BY AIRLESS SPRAY

ZINGA can be applied using an airless spray gun. A 19 thou tip is best for general application, narrow or wide fan as the job requires.

In order to ensure good circulation of the ZINGA, it should be diluted 5 to 7% (mass on mass – see below dilution table) depending on pressure at the nozzle and nozzle opening. More dilution for the same nozzle will give a smoother surface finish (less porous).

For more technical data, see ZINGA Technical Data Sheet.

stripe

Contact Us

    Igoe International Ltd – ZINGA Distributors

    135 Slaney Road,
    Dublin Industrial Estate
    Glasnevin
    Dublin D11 AW6D
    Ireland

    Website www.zinga.ie

    See also www.igoe.ie

    01 830 22 50 / 830 22 49

    info@igoe.ie